Lonsdor K518 Pro Program 2022 Nissan Ariya All Keys Lost

 Today we’ll show how to program 2022 Nissan Ariya all keys lost with Lonsdor K518 Pro Key Programmer by OBD. In the process, we’ll use the NS-40 BCM cable together with K518 Pro device.

This is an electric car and the BCM module is in the front of the assistant driver seat.

• Connect the NS-40 cable to the BCM. We’ll need to remove this port and connect to the female port. Connect the male port to the female port.
• Connect to OBD

We’ll program this original key to this car.

Push function >> Immo & Remote >> NISSAN >> Select from vehicle >> Ariya >> 2022- >> All smart key lost

Lonsdor K518 Pro prompts:

This function requires to unplug BCM connector, then use Nissan-40 specific cable to connect BCM, press OK to continue.

All keys of this vehicle must be re-programmed, press OK to continue.

Turn ignition off.

Turn on Hazard warning lights.

Stay at P or Neutrol gear.

Steering column is in unlocked state.

Start to read key ID:

Put a smart key(to be programmed, with logo upwards) flat on ignition switch, ensure the key’s logo end is right on the ignition.

Note:

1. Do not move the key from ignition.
2. Do not press the key’s any button.
3. Do not insert or remove the little mechanical key from the key.

Count of new keys: 0

Count of old keys: 1

Current key count in total: 1

Here requires to read ID of the keys to be programmed.

Max of new keys to be programmed: 2

Max of all keys: 4

Click OK to read next key.

Click Cancel to next step.

• bit PIN of this vehicle has been read out.

It can be used when program key on AKL condition!

Start to program key.

Put a smart key(to be programmed, with logo upwards) flat on ignition switch, ensure the key’s logo end is right on the ignition.

Note:

1. Do not move the key from ignition.
2. Do not press the key’s any button.
3. Do not insert or remove the little mechanical key

Programming successful.

Click OK to program next key.

Click Cancel to complete.

Count of keys programmed successfully: 1

1. In turn to press each key’s Lock and Unlock buttons, check if it works normally.
2. Check if each key can start car separately. After finish above operations, click OK to end procedure.

After checking all keys, do not exit this function.

Operate as per the prompts below and click OK:

1. Unplug the connector, re-install vehicle’s gateway module.
2. Connect the device to OBD port, turn ignition on.

Lock OK, unlock OK, all goes well.

Done.

www.obdexpress.co.uk