Confirmed! Launch X431 ECU & TCU Programmer clone BOSCH MED17.8.10 TC1728 ECM on bench perfectly. No need X431 tablet! Easy operation with the wiring diagram in the software. Only 2 or 3 Minutes!
Here is the operation procedure.
1.Device connection
Connect X431 ECU Programmer to a computer via USB cable
Open X-431 ECU & TCU Programmer software
Input med17.8.10 in the search box to quickly find the ECU model
It's GreatWall Hover 62014–2018 TGI 1497 164 MED17.8.10 HW2_TC1728
Double click the ECU to enter the main operation interface
Obtain the wiring diagram by clicking "Direct connection of diagram"
Follow the diagram to connect X-431 ECU Programmer and Bosch MED17.8.10 ECM with the BENCH mode line properly
Connect the power supply to the programmer as well
Start to read and write ECU.
2.Read and write Bosch MED17.8.10 ECM
First, read chip ID
Next, read the original EEPROM data and save the data
Then, read the original FLASH data and save the data
Last, disconnect
After backup the original Bosch ECU data, use the same steps to read and save the new Bosch ECU.
Finally, upload the corresponding files to write into the new Bosch ECU
Wait a while until the operation is completed.
Alright! Launch X431 ECU Programmer clone MED17.8.10 ECU successfully.
LAUNCH X431 X-PROG3 with PC Adapter can perform this function as well.
No comments:
Post a Comment