Yanhua Mini ACDP 2 Add 2012 Porsche Cayenne Success

 This is a quick demo on how to add 2012 Porsche Cayenne key with Yanhua Mini ACDP 2 + Module 10 by bench.

Step1. Remove the KVM from underneath the right hand side of the steering wheel.

Step2. Read data using ACDP.

Mini ACDP >> Porsche >> New Porsche add key/all key lost >> ICP IMMO >> MC9S12XEP100(Mask 1N35H) >> Add key(auto mode)

Please use the ACDP standard power adapter(voltage+ 12V, current >= 2.5A)

OK >> Continue

It is detected that the BCM module chip has been encypted.

Continue >> Continue

Reading PFLASH data, please wait…

Please save PFLASH data file.

Backup file succeeded.

Reading EEPROM/DFLASH data, please wait…

Please save the original EEPROM data file.

Backup file succeeded.

Please save the original DFLASH data file.

Backup file succeeded.

Step3. Write new key data using ACDP.

Notes:

1. Keep the ACDP device power-on. Disconnect the OBP+ICP adapter and ACDP device firstly.(keep the OBP+ICP adapter, BCM interface board and BCM module connected).
2. Connect the ACDP device to the BAV-KEY adapter and put the key correctly in the BAV-KEY adapter.

Reading key info…

Select a key position: Key5

Programming key… please wait

Please store the DFLASH data file after adding a new key.

Backup file succeeded.

Step4. Write new key data back to module using ACDP.

Notes:

1. Keep the ACDP device power-on. Disconenct ACDP device and BAV-KEY adapter firstly.
2. Then connect ACDP device, OBP+ICP adapter, BCM interface board and BCM module.
3. Check the crystal oscillator package of BCM module: EXT1 short — circuited for ceramic packaged crystal oscillator, EXT2 short — circuited for metal packaged crystal oscillator.

Continue >> Continue

Backup file succeeded.

Reading EEPROM/DFLASH data, please wait…

Please save the original EEPROM data file.

Backup file succeeded.

Please save the original DFLASH data file.

Backup file succeeded.

Please select the DFLASH data file after adding a new key.

Wirting EEPROM/DFLASH data…

Adding key completed. Please install the BCM module back to vehicle to confirm that new key can be used normally.

Step5. Reinstall module to the vehicle and test the remote.

The new remote can work.

Done.

www.obdexpress.co.uk