This is a guide for SUPER MB PRO M6+ PRO Mercedes-Benz & BMW
configuration step by step.
Plug the M6+ PRO into the power supply or connect the OBD
to the test vehicle, and plug in the USB/LAN cable of the M6+ PRO.
Turn on the computer and plug in the computer USB/LAN cable.
Open the computer network configuration interface and find the Realtek USB
FE Family Controller network/the network adapter that comes with the
PC.
Click "Properties" — TCP/IPV4, and set the IP address as shown in the figure
below.
Click "Advanced", and add a group of network IP addresses as shown in the
figure below.
TCP/IP Address
IP address: 172.29.127.45
Subnet mask: 255.255.0.0
Click "OK". After the configuration is successful, the display is as
follows.
For the same computer, if you replace a new M6+ PRO, you need to reset the IP address.
After the setting is completed, the computer is successfully bound to the M6+
PRO and there is no need to set the IP address again for wired and wireless
Internet access. (Use LAN port connection mode, no need to re-set IP when
changing devices).
You can test Mercedes-Benz normally. Please connect the diagnostic cable
with SUPER MB PRO
BMW wireless BMWAiCode configuration(only for F+G chassis)
Connect to the M6+ PRO -***, password: 123456789, wirelessly, press and hold
the M6+ PRO switch button for 3 seconds, and the M6+ PRO host wireless indicator
will flash. The computer-side BMWAiCoder configuration is as
follows:
BMW wired BMWAiCode configuration(only for F+G chassis)
Connect the USB/LAN cable, press and hold the M6+ PRO switch button for 3S,
and the M6+ PRO host wired indicator light will flash. The computer-side
BMWAiCoder configuration is as follows:
BMW wired and wireless E-Sys configuration(only for F+G chassis)
Connect to the M6+ PRO -*** wirelessly, press and hold the M6+ PRO switch
button for 3 seconds, and the M6+ PRO host wireless indicator will flash. On the
computer side, select the following for direct connection. Wired is similar, no
setup required.
BMW wired ISTA configuration(only for F+G chassis)
Connect the USB cable, press and hold the M6+ PRO switch button for 3S, and
the M6+ PRO host wired indicator light will flash. The computer ISTA
configuration is as follows:
BMW Wireless ISTA configuration(only for F+G chassis)
Connect to the M6+ PRO -*** wirelessly, press and hold the M6+ PRO switch
button for 3 seconds, and the M6+ PRO host wireless indicator will flash. The
computer side is selected as follows:
The mobile phone BWM APP adopts wireless connection. (only for F+G
chassis)
Connect to the M6+ PRO -***, password: 123456789, press and hold the M6+ PRO
switch button for 3 seconds, and the M6+ PRO host wireless indicator will
flash.
Supported BMW models and years.
www.obdexpress.co.uk
No comments:
Post a Comment