Lonsdor has newly released Toyota 4A LT30–01 Universal Smart Key for latest models. Supported Corolla(2019-), Corolla Cross(2019-), Levin(2019-), Allion(2016-) and Camry(2024-). Following we’ll show how to program 2024 Toyota Corolla all keys lost with Lonsdor K518 Pro as an example(adding key is the same process).
Connect K518 Pro & FP-30 Cable to OBDII port.
Immo & Remote >> Toyota >> Select from type >> All smart key lost >> Type 3(2022-) >> 4A >> Key count
Please swtich ignition on.
Current key count: 2
Backup immo data >> OK
Please make sure the K518 Pro device is well connected to network before operation!
During the use of this function, please do not operate abnormally, or maliciously steal relevant data, otherwise this device will be locked and cannot be unlocked!
Please turn ignition on, if fails, please turn on 2 flashing lights or cycle emergency flasher 2 times from "ON" to "OFF".
Save immo data file.
Immo data backed up successfully.
Add smart key >> OK
Please keep vehicle fully charged, in case of the faults caused by low battery power!
Please switch ignition on.
Load the read D-FLASH data of PEPS to acquire 12-bit PIN code.
Check current key count.
Count of the registered keys: 2
Count of registrable keys: 5
Hold the registered key’s back closer to Start button, when buzzer beeps once, take the key away from the button.
Operation completed!
Count of registered keys: 3
Count of registrable keys: 4
Please turn ignition off, check if the key works properly, if it doesn’t have remote function, please follow the prompts to operate, click OK to continue.
Please switch ignition ON.
Hold a programmed smart key closer to Start button, then hear one beep.
The new key programming has completed.
Both LT30 4A Smart Key and original key can work well.
Done.
No comments:
Post a Comment