CGDI Prog BMW tech support:
CGDI BMW Feedback: (updated in 04.2018)
19-03-2018, 11:04 AM
Excellent tool so far. no bricks or problems.
extremely fast for cas1, 2 & 3
for cas3+ if need downgrade 10 minutes and seems safe, ISN read from DME 10 minutes does not support all DME is down side.
make sure you have proper power on the car
cas4 /+ did not check
extremely fast for cas1, 2 & 3
for cas3+ if need downgrade 10 minutes and seems safe, ISN read from DME 10 minutes does not support all DME is down side.
make sure you have proper power on the car
cas4 /+ did not check
19-03-2018, 15:59 PM
cas4 F10 – ok (new key)
cas4+ F10 – ok (new key) isn from org key or dump DME
fem/bdc F31 – ok – reset mileage, change isn, change vin, make keys with oryginal key and with dump from DDE
cas3+ E60- ok , downgrade and make key with isn from org key
cas4+ F10 – ok (new key) isn from org key or dump DME
fem/bdc F31 – ok – reset mileage, change isn, change vin, make keys with oryginal key and with dump from DDE
cas3+ E60- ok , downgrade and make key with isn from org key
28-03-2018, 05:51 AM
08-Mini Cooper – Added Key With CGDI Bmw programmer
the wording was alittle confusing when it ask u is it a prox or non prox this car was a non prox so u push yes and for add keys u put your first key in the programmer slot then put your unlocked key in and then your done just make sure u have jumpers Hooked up so u don’t lose power and I had a surge protector on my obd to stabilize the power cas3+
the wording was alittle confusing when it ask u is it a prox or non prox this car was a non prox so u push yes and for add keys u put your first key in the programmer slot then put your unlocked key in and then your done just make sure u have jumpers Hooked up so u don’t lose power and I had a surge protector on my obd to stabilize the power cas3+
07-04-2018, 06:06 AM
So I purchased the cgdi programmer.
I figured out how make key for cas2-3 but I can’t figure out how to use this programer for cas4. I tried looking online but only find for cas3,no instructions for cas4, can anyone tell me steps for cas4 I have f10 I can try one.
07-04-2018, 07:22 AM
Cas4 can only be done by reading DFlash from Freescale cpu then load into programmer software and generade key. It can no ne done by obd.Need xprog or vvdi prog to read the dflash.
10-04-2018, 06:55 AM
work like VVDI2 – synchronization every month
No comments:
Post a Comment