Solved: Lonsdor K518ISE/ KH100+ Start Car OK But Remote Failed

 Problem: Having programmed 3 keys with Lonsdor KH100+ for 2020 Toyota RAV4, we tried the emulator. Each of 3 emulators has the same problem that the car does not close and does not open by pressing the remote control button.

The smart & emergency start is OK, but RKE function does not work.

Any ideas? Please advise.

Solution

Tip: Make sure to activate Lonsdor Toyota AKL License Online Calculation before programming keys.

• For Lonsdor KH100+

Special functions >> FT smart key >> 8A >> Modify remote count value

Only modify the last values to 1200, increase the values each time until remote works.

• For Lonsdor K518ISE

Special functions >> key settings >> FT smart key >> 8A >> Modify remote count value

Modify remote values to 1000, second time 1300, increase 300 each time until remote works.

Operation Guide on K518:

What to do if there is no RKE function after key generation is complete?

• Enter "Modify remote count value" menu, and follow the prompts to put the key(H0410C, H0440C, PH0440C) into the card slot to identify. After identification, no need to care what the value is, just click "OK".
• The system will let you enter a number, the first time enter 1200, then click "OK" until it prompts success. At last you press the remote for 5–6 times to check if its RKE function works.
• If not, enter "Modify remote count value" menu once again, the second time you enter 1400, then test the remote function. If the remote still doesn't work, each time you increase the previous value by 200, until the remote's RKE function works normally.

Technical support

www.obdexpress.co.uk