Renault can clip v195 installation was successful, but there was a problem of “no sensor detected. Check the sensor connections and ensure that the supply to the vehicle is correct, then try again.”.
Possible reason:
The driver was not installed
Working solution:
CLIP driver installation completes after running Crack Renault CLIP, installing Renault CLIP software, setting up CLIP properties, registering CLIP.
How to install Renault CAN Clip V195 driver on Windows 7:
if the driver has been set up as above video, try run CLIP again. If the error message remains, please try the solutions below:
Second, check the connection of the renault can clip diagnostic tool and the car.
Using the obdii cable to connect the can clip unit to the obd port on the car
And if all is well connected, the four LEDs should be lighted
Good luck!
Renault can clip v195 tech support:http://blog.obdexpress.co.uk/tag/renault-can-clip/
No comments:
Post a Comment