FormulaFlash software update V1.2.0.0 adds direct Bench Mode operations for locked BMW Bosch MD1 and MG1 engine control units (DDE8 and DME8). Technicians can now service these modules safely without opening the casing or using external mail-in unlock services.
Key Technical Features
- Safe Bench Access: Connect directly to ECU plug pins; no cover removal or pin soldering required.
- Direct Module Operations: Performs BENCH Unlock, DFLASH/PFLASH (FLASH & EEPROM) reading/writing, and automatic Checksum verification.
- Self-Contained Protocol: Eliminates reliance on third-party unlock services.
Supported Control Unit Specs
This protocol targets TC298 and TC299 TriCore chips inside BMW DDE8 (diesel) and DME8 (gasoline) controllers:
ECU ModelMicrocontrollerOperations SupportedBosch MD1CP032TC299BENCH Unlock + Read/Write FLASH + EEPROM + ChecksumBosch MD1CS001TC298BENCH Unlock + Read/Write FLASH + EEPROM + ChecksumBosch MG1CS024TC298BENCH Unlock + Read/Write FLASH + EEPROM + ChecksumBosch MG1CS049TC298BENCH Unlock + Read/Write FLASH + EEPROM + ChecksumBosch MG1CS0201TC298BENCH Unlock + Read/Write FLASH + EEPROM + Checksum
Vehicle Compatibility
Applies to BMW G-chassis vehicles running DDE8/DME8 platforms:
- BMW 3 Series (G20/G21)
- BMW 5 Series (G30/G31)
- BMW X3 (G01)
- BMW X5 (G05)
Update Procedure:
Connect your FormulaFlash ECU Programmer to your PC, launch the desktop software, and perform the free online update to install version 1.2.0.0.
No comments:
Post a Comment