This is a quick demo on how to program 2020 Jeep Wrangler all keys lost with Autel & Xhorse key tools. The Jeeps has 2 gateway connectors, one is back in the storage tray at assistant seat. Just press the button to take out connector. The other one is under lower left corner of steering wheel, remove that part to access the connector. Either is OK.
Tools Required
I'll use ADC 2011 cable to program the key.
After using Autel KM100 to generate the universal key.
Connect VVDI Key Tool Plus into OBD, enter into
IMMO programming >> Jeep >> Select by area >> North America >> Wrangler >> 2020–2021 >> Smart key system >> Start programming
Please use 12+8 Adapter, the gateway connector is generally behind the CD player(Commander, Cherokee), under the co-pilot glove box(Grand, Cherokee), and under the steering wheel(Compass, Wrangler).
Press "OK".
Press "Read PIN code".
Open network connection, it takes a few minutes during calculating password.
Switch ignition off, turn on the security warning light(double flash lights).
Press "OK".
Key Tool Plus Pad starts calculating…
*Don't scare if it appear on the screen that failed. This will happen until getting the password.
Passwords were successfully read out: 86715
Press "Add smart keys".
Switch ignition off, turn on the security warning light.
Place the smart key to be programmed inside the car, take other keys out of the car, make sure there are no wireless devices near the smart key.
Inputpassword: 86715
After clicking "OK", keep the top of smart key to be programmed touching the start button until the device prompts to release.
Current key number: 1
Program completed!
Remove OBD to have a test, the car can start.
Done.
No comments:
Post a Comment